Differences between revisions 4 and 5
Revision 4 as of 2015-03-04 12:48:27
Size: 1121
Comment:
Revision 5 as of 2015-03-04 12:55:00
Size: 1325
Comment:
Deletions are marked like this. Additions are marked like this.
Line 13: Line 13:

'''Remark : The reconstruction software from October/November CERN TB still works just the database paths and the processor Ahc2Calibrations needs to be modified!!!''' The source file is available [[|here]]

Campaigns in 2015 :

  • February 2015 :

We had a TB period of about 1 week in February at DESY. The Setup was 5 big layers (Layer 12, 13, 14, 15 and one special layer composed of the 2 new ITEP boards and the SMD Mainz board) in an airstack configuration using the tungsten frames. The goal of this testbeam was to get a MIP Calibration for the outer tiles of theses layers and cross-check few things from CERN PS Testbeam.

In overall, the testbeam was a success. Thanks to it, we can get a light yield measure for the new Mainz board, cross-check results with the ones at CERN and get a better understanding of the electronics. One change was operated on the Layer 13. As we observed that the gain for that layer was too low at CERN, we decided to change the pre-amplifier values to lower values.

CERN PS

DESY Feb 2015

325fF

250fF

350fF

275fF -> 250fF

275fF

225fF

275fF

225fF

Remark : The reconstruction software from October/November CERN TB still works just the database paths and the processor Ahc2Calibrations needs to be modified!!! The source file is available [[|here]]

A list of remarks, comments and runs is available here.

airstack.jpg

tb2015 (last edited 2017-01-05 13:04:46 by AmbraProvenza)